60A into 12V lithium, lead-acid or LiFePO4 banks with adjustable voltage and current, one rung below the 180A YZ3000 for banks that do not need the full outp...
| Input Voltage | 100-240V AC |
|---|---|
| Output | 14.6V 60A |
| Efficiency | >88% |
| Protection | OVP/OCP/SCP/OTP |
The YZ1000 pushes 60A into 12V lithium, lead-acid or LiFePO4 banks, with adjustable voltage and current - the rung below the 180A YZ3000.

60A with adjustable voltage, for 12V lithium, lead-acid or LiFePO4 banks. The YZ800S sits below at 40A; the 180A YZ3000 above it is for the largest high-capacity banks.


60 A is 876 W of charging current, and the effect is time. A 300 Ah bank that takes fifteen hours at 20 A is back in about five at 60 A, before the constant-voltage taper. For a boat, a workshop bank or an off-grid store that has to be ready the same day, that difference decides whether the charger is the bottleneck.
Both settings are exposed rather than fixed at the factory. Voltage follows the chemistry: 14.6 V for 4S LiFePO4 and for 12 V lead-acid absorption, 12.6 V for 3S lithium-ion. Current is turned down to whatever the bank or the cabling will accept, which is the usual answer when one charger has to serve packs of different sizes.
A 3S lithium-ion pack charges at 12.6 V, not 14.6 V - the 14.6 V setting overcharges it. 24 V banks need 29.4 V (7S lithium-ion) or 29.2 V (8S LiFePO4) and cannot be served by this output at all. The series count decides the voltage; the label on the case does not.
60 A is past the point where the connector is an afterthought. The output needs cable and a connector rated for the current, and the same applies to the run between charger and bank. Tell us the connector on the battery and we build to it rather than shipping a standard plug and leaving the adaptation to you.
The YZ800S sits below at 40 A, the YZ3000 above at 180 A. 60 A is the step that covers most workshop, marine and storage-bank duty without moving into the very large banks the 180 A unit is built for.
Input 100-240 V AC. Output 14.6 V at 60 A, voltage and current adjustable. Efficiency above 88%. Protection: over-voltage, over-current, short-circuit and over-temperature.
MOQ / lead time / warranty · 1 unit · 10-15 working days · 1 year
Can I charge a 100 Ah bank at 60 A? That is a high rate for the capacity. Turn the current down - adjustability is the reason to specify this build over a fixed one.
Will it charge 12 V lead-acid and 4S LiFePO4 on the same setting? Both finish at 14.6 V, so the voltage setting covers both. Say which pack when ordering so the profile is set correctly.
Does it work on 110 V mains? Input is 100-240 V AC. At 60 A the input draw is worth checking against the circuit.




Other chargers built for the same battery system, from the same factory: