Almost every charger datasheet quotes an IP rating, and almost no buyer is told what the second digit was actually tested against. The difference between IP54 and IP65 decides whether a unit survives a wash-down bay or fails in its first season, so it is worth twenty minutes of precision.
The first digit covers solids, from 0 to 6. The second covers liquids, from 0 to 9. IP65 is therefore a dust rating of 6 combined with a water rating of 5, and neither digit tells you anything about the other. A product can be dust-tight and still fail under a hose; it can also shrug off rain and choke on fine conductive dust. Marketing language collapses these into one word, waterproof, which is why so many installations are specified from a word rather than a number.
Level 6 is dust-tight, not merely dust-protected. Level 5 allows a limited quantity of dust to enter as long as it does not interfere with operation; level 6 allows none. The test places the enclosure in a dust chamber with circulating talc for up to eight hours, with a partial vacuum inside so any leak draws dust in. If dust appears inside, the rating fails. For a charger in a foundry, a feed mill or a workshop with carbon dust in the air, this distinction is the one that matters, because conductive dust across a live board is a short circuit, not a cosmetic problem.
Level 5 is protection against water jets: a 6.3 mm nozzle delivering 12.5 litres per minute at 30 kPa, held about three metres away, from any direction, for at least three minutes. No water may enter in a quantity that causes harmful effects. Read that specification carefully and the limits become obvious. Thirty kilopascals is a gentle spray, roughly a garden hose on a low setting. A pressure washer at close range operates at a hundred times that pressure, and no IP65 unit is obliged to survive it.
In practice, the enclosure is rarely the weak point. The failures we see cluster in four places: the cable gland, where the cable jacket does not match the gland's sealing range; the connector interface, which may be rated lower than the box it is bolted to; the LED window or display cutout; and the screw bosses, where over-torquing cracks a gasket seat. A unit with a certified IP65 housing and an unsealed connector is, functionally, an unsealed unit. When you specify, the connector rating has to be stated alongside the enclosure rating, or the number means very little.
Two constructions reach IP65, with different trade-offs. A fully potted aluminium housing has no internal air volume, so there is nothing for moisture to condense into, and the potting compound conducts heat from the components into the aluminium walls. The cost is that the unit cannot be opened for repair, and it is heavier. A gasketed plastic enclosure can be serviced, but the gasket ages, takes a compression set and eventually lets water past, and plastic conducts heat poorly, so components run hotter for the same output. For equipment that is cleaned daily and expensive to service in the field, potting usually wins; for equipment that will be maintained on a bench, a serviceable design is worth the compromise.
Sealing removes convective cooling. A charger rated for 40 degrees ambient in free air will run hotter once it is inside a sealed stainless cabinet in direct sun, where internal air can be 15 degrees above outside. The correct approach is to derate output at elevated ambient, or to mount the housing so its fins see outside air, rather than to add a fan, because a fan opening is an IP hole by definition. Any specification conversation about IP65 that does not also discuss derating is incomplete.
Ask for the IP rating with the test standard named, the connector rating, the gland type and cable range, the derated output at the ambient temperature inside the actual cabinet, the condensation strategy, and whether a salt-fog test applies. A supplier who can answer all six is quoting a product; a supplier who answers only the first is quoting a label.
Related models: see the 24 V 20 A waterproof on-board charger for AGV and floor equipment, a sealed enclosure built for wash-down environments, and the 14.6 V 20 A waterproof on-board charger for marine and RV installation.